|
WRAP-ON
|
|
| |
Item No. |
Available Lengths |
Watts |
amps @ 120 VAC (Approx. ) |
14060 |
60' |
300 |
2.5 |
| |
| This pre-assembled cable has been designed for the sole purpose of preventing the formation of ice dams on pitched roofs with non-combustible tab shingles and in metal or plastic gutters and downspouts. It provides drainage channels so that as natural thawing occurs, water has a path to flow off the roof and through the gutters and downspouts. This cable is not for use on a flat roof nor is it intended to clear the roof of snow and ice. The installation of this product is simple and it can be used with either metal or plastic gutters. Read and follow all instructions and pay particular attention to the following points: Install the cable when the outside temperature is above 50˚F because at lower temperatures shingle material may be brittle; Clear all leaves, pine needles and debris from the roof, gutters and downspouts before operating the cable. Do not plug the cable in unless it has been completely uncoiled or it will be damaged. |
| |
| Each package contains one ready-to-install cable, shingle clips, cable spacers and complete installation instructions. You will also need a tape measure, marker, gloves, ladder and a weatherproof GFCI outlet with control switch. |
| |
| Roof and Gutter Cable Specifications |
- They can be applied on pitched roofs with non-combustible tab shingles, in gutters and in downspouts.
- Roof and Gutter Cables operate at 120 volt, 5 watts per foot. They are cUL Listed and CSA certified.
|
| |
| Instructions for Cable Length Selection |
| |
| Selecting and installing the right cable is simple, just follow these five easy steps. |
| |
- Measure roof overhang and select corresponding multiplier.
- Measure length of roof to be protected and multiply by multiplier to obtain length of cable required for the roof.
- Measure length of gutter (if any).
- Measure length of cable to go around dormers (if any).
- Measure length of downspouts. Multiply by 2 if double cable is used in downspout.
|
| |
| Total length of cable required is sum of 2, 3, 4 and 5. Select from the standard lengths to meet your needs. |
| |
Width of Overhang |
Multiplier with Gutter |
Multiplier without Gutter |
|
0" |
2.5 ft. |
1.5 ft. |
|
6" |
2.8 ft. |
1.8 ft. |
|
12" |
3.3 ft. |
2.3 ft. |
|
18" |
3.7 ft. |
2.7 ft. |
|
24" |
4.2 ft. |
3.2 ft. |
|
30" |
4.7 ft. |
3.7 ft. |
|
36" |
5.2 ft. |
4.2 ft. |
|
42" |
5.6 ft. |
4.6 ft. |
|
48" |
6.1 ft. |
5.1 ft. |
|
| |
