Drill Diameter: 7/8" Min. Depth: 2-1/2" Thread Depth: 1-3/16" The Steel Drop in is an all-steel, machine bolt anchor available in carbon steel and two types of stainless steel. It can be used in solid concrete, hard stone, and solid block. EDGE DISTANCE - SHEAR: For shear loads, an edge distance, E, of 12 diameters (12D) or greater should be used to obtain the maximum shear load. The minimum recommended edge distance, E, is 8 diameters (8D) at which point the shear load should be reduced by 50%. Edge distances closer or less than 8 diameters (8D) need to be field tested. Actual base material conditions will determine any applicable reduction factor. The following table lists the load reduction factor, Re, for each anchor diameter, D, based on the anchor center to edge distance. The following approvals and listings are for reference purposes. They should be reviewed by the design professional responsible for the product installation to verify approved base materials, sizes, and compliance with local codes: -ICBO ES Research Report No. 5225 -COLA Research Report No. 24960 -Factory Mutual Serial No. 15219 / 1952 -Underwriters Laboratories File EX 1289 (N) Federal Specification: Meets the proof load requirements of FF-S-325C, Group II, Type 3, Class 1 (superseded) Metro Dade - pending

SOLD IN BOXES OF 25